論文

2015年

Die-dending of adhesively bonded sheet metals

Key Engineering Materials
  • Michihiro Takiguchi
  • ,
  • Taro Tokuda
  • ,
  • Tetsuya Yoshida
  • ,
  • Takeshi Uemori
  • ,
  • Fusahito Yoshida

626
開始ページ
103
終了ページ
108
記述言語
英語
掲載種別
研究論文(国際会議プロシーディングス)
DOI
10.4028/www.scientific.net/KEM.626.103
出版者・発行元
Trans Tech Publications Ltd

In this paper, the deformation behavior of adhesive layer in die-Bending for adhesively bonded sheet metals was investigated by experiments and finite element method (FEM). We paid special attention to the bending/unbending shear deformation of the adhesive layer during the die-Bending of adhesively bonded sheet metals by using highly ductile acrylic adhesive. Major results obtained are summarized as follows: (1) The bending/unbending shear deformation of the adhesive layer was observed during the die-Bending. (2) The punch radius has a large influence on the die-Bending in the adhesively bonded sheet metals. (3) It is desirable to perform die-Bending at high speed as well as air-Bending. © (2015) Trans Tech Publications, Switzerland.

リンク情報
DOI
https://doi.org/10.4028/www.scientific.net/KEM.626.103
ID情報
  • DOI : 10.4028/www.scientific.net/KEM.626.103
  • ISSN : 1013-9826
  • SCOPUS ID : 84907080683

エクスポート
BibTeX RIS