論文

2017年11月

Conceptual design study of pellet fueling system for DEMO

Fusion Engineering and Design
  • S. Tokunaga
  • ,
  • A. Matsuyama
  • ,
  • Y. Someya
  • ,
  • H. Utoh
  • ,
  • Y. Sakamoto
  • ,
  • N. Asakura
  • ,
  • K. Tobita

123
開始ページ
620
終了ページ
623
記述言語
掲載種別
研究論文(学術雑誌)
DOI
10.1016/j.fusengdes.2017.02.079

© 2017 Elsevier B.V. Requirements for pellet injection system for a Japanese DEMO concept are comprehensively assessed in order to elucidate direction and target of R&D. A fusion output control simulation study using 1.5D transport code is carried out to estimate requirement of fuel particle source. Next, multivariable parameter dependence survey of the fuel deposition source on pellet speed, poloidal injection angle, pellet mass and pedestal height is performed. The conditions to achieve the target fueling depth derived from the output control study are shown. The AUG calibrated relation is referred to consider spatial restriction of tokamak geometry which relates maximum pellet velocity to curvature of pellet guide tube. Then the restriction is collated to the results of multivariable survey to find the most advantageous pellet speed, injection angle, and pellet mass which is consistent with both output control and tokamak geometry. Consequently, a conceptual design of fuel pellet injection system as the R&D target toward to DEMO is proposed.

リンク情報
DOI
https://doi.org/10.1016/j.fusengdes.2017.02.079
Scopus
https://www.scopus.com/record/display.uri?eid=2-s2.0-85014759425&origin=inward
Scopus
https://www.scopus.com/inward/record.uri?partnerID=HzOxMe3b&scp=85014759425&origin=inward
Scopus Citedby
https://www.scopus.com/inward/citedby.uri?partnerID=HzOxMe3b&scp=85014759425&origin=inward