Misc.

Jul 10, 2008

Estimation of Electromagnetic Emissions from PCBs with a Connector through the Common-Mode Antenna Model (Part 2) : Model Improvement by Considering Connector Inductance

IEICE technical report
  • WAKADUKI Yuri
  • ,
  • TORIGOE Makoto
  • ,
  • WATANABE Tetsushi
  • ,
  • TOYOTA Yoshitaka
  • ,
  • IOKIBE Kengo
  • ,
  • KOGA Ryuji

Volume
108
Number
132
First page
37
Last page
42
Language
Japanese
Publishing type
Publisher
The Institute of Electronics, Information and Communication Engineers

In this paper, we apply a connector model with an inductance to the common-mode antenna model. The common-mode antenna model is able to estimate common-mode radiation from a printed circuit board (PCB) fast and with low calculation cost. The previous report described that the model estimated radiation from PCBs with interconnections, depending on pin configurations of the connector. However, the calculation did not follow the frequency shift depending on pin configuration. The shift seems to result from the effective inductance of connector pins. Therefore, we developed the model considering the inductance. It was found that the modified common-mode antenna model with the connector inductance followed the frequency shift of radiation spectrum. As a result, the radiation spectrum obtained from the modified common-mode antenna model has good agreement with the measured spectrum within an error of 2dB.

Link information
CiNii Articles
http://ci.nii.ac.jp/naid/110006990434
CiNii Books
http://ci.nii.ac.jp/ncid/AN10013108
URL
http://id.ndl.go.jp/bib/9605413
ID information
  • ISSN : 0913-5685
  • CiNii Articles ID : 110006990434
  • CiNii Books ID : AN10013108

Export
BibTeX RIS