論文

査読有り
1998年9月

Identification of the machine settings of real hypoid gear tooth surfaces

JOURNAL OF MECHANICAL DESIGN
  • C Gosselin
  • ,
  • T Nonaka
  • ,
  • Y Shiono
  • ,
  • A Kubo
  • ,
  • T Tatsuno

120
3
開始ページ
429
終了ページ
440
記述言語
英語
掲載種別
研究論文(学術雑誌)
DOI
10.1115/1.2829170
出版者・発行元
ASME-AMER SOC MECHANICAL ENG

In the spiral bevel and hypoid gear manufacturing industry, master gear sets are usually developed om initial machine settings obtained from computer. software or instruction sheets. These initial machine settings are then modified until a satisfactory bearing pattern is obtained, a process called bearing pattern development Once a satisfactory bearing pattern is obtained manufacturing errors and heat treatment distorsions can be accounted for by proportionally changing the machine settings according to the results of a V-H test in which the pinion vertical and horizontal positions are modified until the bearing pattern is acceptable.
Once a satisfactory combination of master pinion and gear is obtained their actual tooth surfaces usually do not correspond to those of the initial theoretical model, and the theoretical pinion and gear surface definitions are unknown.
This paper presents a computer algorithm used to identify the machine settings producing a theoretical tooth surface closest to that of a measured surface, what the authors call Surface Match, in order to effectively simulate the kinematical behavior of real gear teeth. The approach is applicable to both Ist and 2nd order surface errors, including profile deviation, for any cutting process. However given the availability of experimental data for the Fixed Setting(TM), Formate(TM) and Helixform(TM) cutting processes, the examples presented in the paper are related to these cutting processes.

Web of Science ® 被引用回数 : 47

リンク情報
DOI
https://doi.org/10.1115/1.2829170
Web of Science
https://gateway.webofknowledge.com/gateway/Gateway.cgi?GWVersion=2&SrcAuth=JSTA_CEL&SrcApp=J_Gate_JST&DestLinkType=FullRecord&KeyUT=WOS:000075921800010&DestApp=WOS_CPL

エクスポート
BibTeX RIS