論文

2010年

S0304-1-3 微少押込み試験によるTi-Mo合金の結晶方位評価([S0304-1]応力・ひずみ測定)

年次大会講演論文集
  • 木村 訓明
  • ,
  • 清水 一郎
  • ,
  • 多田 直哉
  • ,
  • 竹元 嘉利

2010
開始ページ
265
終了ページ
266
記述言語
日本語
掲載種別
DOI
10.1299/jsmemecjo.2010.1.0_265
出版者・発行元
一般社団法人日本機械学会

In recent years, β-type Ti alloys have been attracting much attention for industrial applications, not only by its high specific strength and superior formability but also by special features such as low elastic modulus and extraordinary plastic deformation behavior. However, the studies on β-Ti alloys are still less than those on other types of Ti alloys. Hence, the evaluation processes of various properties of β-Ti alloys have still not been established nevertheless of their importance for industrial applications. The aim of the present study is to evaluate the crystal orientation of grains of β-Ti alloys by means of micro indentation technique. Ti-14Mo and Ti-20Mo alloys, whose primary deformation mechanisms are mechanical twin and coarse slip, respectively, were employed as typical β-Ti alloys. The detailed investigations were performed on the relationship between the crystal orientation and the indentation behavior. The results revealed that the lines which appeared around the indentation of Ti-14Mo almost corresponded to twin boundaries, while those of Ti-20Mo were slip lines. The distortion of indentation shapes also appeared on both Ti-Mo alloys. Based on these results, the procedure of crystal orientation evaluation by micro indentation test was discussed.

リンク情報
DOI
https://doi.org/10.1299/jsmemecjo.2010.1.0_265
CiNii Articles
http://ci.nii.ac.jp/naid/110008701213
CiNii Books
http://ci.nii.ac.jp/ncid/AA11461871
ID情報
  • DOI : 10.1299/jsmemecjo.2010.1.0_265
  • CiNii Articles ID : 110008701213
  • CiNii Books ID : AA11461871

エクスポート
BibTeX RIS