In this paper, protection resistance was measured as a parameter for the 3D shape of the dendrite, which was produced on the copper, printed wired board by the WDT method. The measurement was occurred using the 3D shape measurement system. We measured the 3D shape of a dendrite in a nonuniform electric field with a changing polarity. Moreover, the polar effect of ion-migration was examined by the 3D shape electric field analysis using ANSYS. Consequently, the height of the accumulation things at anode was higher than the negative pole side under round shaped cathode condition. Similarly, the quantity of the accumulation thing is also found larger at anode. On the other hand, the dispersal of the accumulation thing is observed between the anode and the negative pole under a round shaped anode conditions. And it turns out that there is also smaller accumulation thing at the tip part of a round shaped electrode. Moreover, for a same protection resistance, the amounts of generating of the accumulation objects per unit electric charge were larger for round shaped anode conditions comparing to the cathode. It is seen from 3d shape electric field analysis, that horizontal part of the electric field vector at anode is greater than the cathode. At the same time, the field intensity at anode is also larger than cathode. For a round shaped anode in 3D shape electric field analysis, the strongest electric field vector was found between a round shape electrode tip part and flat electrode. Although in the round shape cathode, the electric field vector had become the strongest between the flat electrode and the round shape electrode tip part. The electric field intensity of a nearby flat electrode was strong for a round shape electrode facing the field. Since the action states of the accumulation thing after a short circuit is different depending on the polarity of electrode for a nonuniform electric field conditions, it appears that it will not take much time to occur a failure