論文

査読有り
2016年

Spin turning of hardened steel using a rod tool made of cemented carbide and on-machine forming of rod tool

Materials Science Forum
  • Fumio Koga
  • ,
  • Shinichi Ninomiya
  • ,
  • Kiyoshi Suzuki

874
-
開始ページ
505
終了ページ
510
記述言語
英語
掲載種別
研究論文(国際会議プロシーディングス)
DOI
10.4028/www.scientific.net/MSF.874.505
出版者・発行元
Trans Tech Publications Ltd

Use of a tool driven by a spin turning method on a 5 axis turning center has an advantage in suppressing a tool wear in the external turning of hard-to-machine materials. However, it is important not easy to control a radial runout of the tool periphery in the spin turning. In this research, a simple rod shaped tungsten carbide was applied as a rotating tool to the turning of a hardened steel workpiece (HRC63). In addition, on-machine grinding method was proposed as a measure to minimize a radial runout of the rotating tool. With this technique, a well suited rake angle, relief angle or chip breaker profile could be easily given to the tool. In spin turning of the hardened steel with a WC rod tool, roughness value of the worked surface was reduced and tool wear was suppressed in comparison with the turning without tool rotation. In addition, it was shown that correction of the tool runout and forming of the tool rake face could be done on the machine.

リンク情報
DOI
https://doi.org/10.4028/www.scientific.net/MSF.874.505
ID情報
  • DOI : 10.4028/www.scientific.net/MSF.874.505
  • ISSN : 0255-5476
  • SCOPUS ID : 84991735201

エクスポート
BibTeX RIS