2011年
End-mill Evaluation By Measurement Of Cutting Force
ADVANCED MATERIAL SCIENCE AND TECHNOLOGY, PTS 1 AND 2
- ,
- ,
- ,
- 巻
- 675-677
- 号
- 開始ページ
- 681
- 終了ページ
- 684
- 記述言語
- 英語
- 掲載種別
- 研究論文(国際会議プロシーディングス)
- DOI
- 10.4028/www.scientific.net/MSF.675-677.681
- 出版者・発行元
- TRANS TECH PUBLICATIONS LTD
Evaluation of manufacturing process in milling by direct measurement of cutting force is considered to be effective comparing to indirect measurement of electricity. This paper proposed a new evaluation method of end-mills by the direct measurement of cutting force. Cutting forces were precisely obtained by a 3-component dynamometer during end milling. Each flute cutting forces was evaluated for two types of end-mills (non wear-out, wear-out) by wave patterns of cutting force. A distinctive difference in the two types of end-mills has been clearly seen. The effectiveness of the proposed evaluation method has been clarified.
- リンク情報
- ID情報
-
- DOI : 10.4028/www.scientific.net/MSF.675-677.681
- ISSN : 0255-5476
- Web of Science ID : WOS:000297036200158