論文

査読有り
2018年10月

Cold Plastic Forming of ABS Plastic Pipe

Nanotechnology & Applications
  • Kentaro Tsunoda
  • ,
  • Shinichi Nishida
  • ,
  • Junshi Ichikawa
  • ,
  • Yuta Kashitani
  • ,
  • Yuto Horigome
  • ,
  • Naoki Ikeda
  • ,
  • Hideto Harada
  • ,
  • Nobuyuki Kamei

1
2
開始ページ
1
終了ページ
4
記述言語
英語
掲載種別
研究論文(学術雑誌)

This paper describes about cold plastic forming of ABS plastic pipe. Experiment and Finite element method (FEM)<br />
analysis of pipe expansion process were operated. The application of ABS plastic pipe for air conditioner is under<br />
consideration instead of metal pipe in Japan because of weight saving of air conditioner for lowering the gravity<br />
point against earthquake. The parts of ABS plastic pipe is generally produced by injection molding. The processes<br />
need the cooling time, and it takes much time. In addition, expensive mold die is needed for each application. Thus,<br />
cold plastic forming of ABS plastic pipe was proposed. The cold plastic forming of ABS plastic pipe chosen for<br />
this study is hardly studied by other authors. Product ability of cold plastic forming is higher than the injection<br />
molding or hot working. And the punch and die shape is simple comparing to these process. In this study, pipe<br />
expansion process was operated. The ABS plastic pipe has a 10 mm diameter and 8mm inner diameter and 1 mm<br />
thickness. At first, true stress and true strain curves at any strain rate were measured by ring compression test.<br />
Obtained flow stresses was used to FEM a

リンク情報
URL
http://scivisionpub.com/pdfs/cold-plastic-forming-of-abs-plastic-pipe-563.pdf

エクスポート
BibTeX RIS