2015年
Die-dending of adhesively bonded sheet metals
Key Engineering Materials
- ,
- ,
- ,
- ,
- 巻
- 626
- 号
- 開始ページ
- 103
- 終了ページ
- 108
- 記述言語
- 英語
- 掲載種別
- 研究論文(国際会議プロシーディングス)
- DOI
- 10.4028/www.scientific.net/KEM.626.103
- 出版者・発行元
- Trans Tech Publications Ltd
In this paper, the deformation behavior of adhesive layer in die-Bending for adhesively bonded sheet metals was investigated by experiments and finite element method (FEM). We paid special attention to the bending/unbending shear deformation of the adhesive layer during the die-Bending of adhesively bonded sheet metals by using highly ductile acrylic adhesive. Major results obtained are summarized as follows: (1) The bending/unbending shear deformation of the adhesive layer was observed during the die-Bending. (2) The punch radius has a large influence on the die-Bending in the adhesively bonded sheet metals. (3) It is desirable to perform die-Bending at high speed as well as air-Bending. © (2015) Trans Tech Publications, Switzerland.
- ID情報
-
- DOI : 10.4028/www.scientific.net/KEM.626.103
- ISSN : 1013-9826
- SCOPUS ID : 84907080683