1994年8月
NC工作機械における送り駆動形のトータルチューニングに関する研究(第1報) : 送り駆動機構のモデル化とパラメータの同定
精密工学会誌
- ,
- ,
- ,
- ,
- ,
- ,
- 巻
- 60
- 号
- 8
- 開始ページ
- 1097
- 終了ページ
- 1101
- 記述言語
- 日本語
- 掲載種別
- 研究論文(学術雑誌)
- DOI
- 10.2493/jjspe.60.1097
- 出版者・発行元
- 公益社団法人精密工学会
A model is proposed for the total tuning of feed drive systems in NC machine tools. The model should be sufficiently simple for calculation, yet precise for analysis of servo system stability. Parameters of the model are identified by curve fitting of the frequency response measured by the DAC measuring method. This model was tested by measuring the responses of feed drive systems in a existing machining center. As a result, model was sufficiently correct for practical use.
- リンク情報
-
- DOI
- https://doi.org/10.2493/jjspe.60.1097
- CiNii Articles
- http://ci.nii.ac.jp/naid/110001371644
- CiNii Books
- http://ci.nii.ac.jp/ncid/AN1003250X
- ID情報
-
- DOI : 10.2493/jjspe.60.1097
- ISSN : 0912-0289
- CiNii Articles ID : 110001371644
- CiNii Books ID : AN1003250X
- identifiers.cinii_nr_id : 1000080243054